How do you set up Webroot to scan when you boot up. I set the system to scan on boot up but it doesn
I have set my settings to scan on boot up. But when i boot up it does not do this. I have to manually scan all the time. How do you fix this?
Userlevel 7
Hello there! Welcome to the Webroot Community!
There are a couple of different spot that mention scanning at boot time, so lets quickly check that you have the right one set.
Open WSA
Click the Advanced Settings button at the upper right
Click Scheduler on the left side
In here, make sure that you have the very first item checked: Enable Scheduled Scans. (There IS an item lower down that says to scan at bootup if a scheduled scan was missed. This will NOT work to make the computer scan at boot unless Scheduled Scans are enabled.
Click the dropdown box to set the "Scan Frequency". Select "Scan on Bootup"
Make sure you click SAVE at the bottom, and you should be good to go.
There are a couple of different spot that mention scanning at boot time, so lets quickly check that you have the right one set.
Open WSA
Click the Advanced Settings button at the upper right
Click Scheduler on the left side
In here, make sure that you have the very first item checked: Enable Scheduled Scans. (There IS an item lower down that says to scan at bootup if a scheduled scan was missed. This will NOT work to make the computer scan at boot unless Scheduled Scans are enabled.
Click the dropdown box to set the "Scan Frequency". Select "Scan on Bootup"
Make sure you click SAVE at the bottom, and you should be good to go.
Reply
Login to the community
No account yet? Create an account
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.